Bilge Wiring

robert.tadefa

Cadet
Thread starter
Joined
Aug 20, 2011
Messages
6
I installed bilge pump myself. It just stopped working after a couple of months. When I discovered it didnt work any longer was when water was pouring into the boat and wires were submerged for anextended period of time. Few days. I tried reconnecting the wires and they heat up to the point where a small amount of smoke appears at the connection. Bilge give out a weak noise at the same time.

Do I need an entire new wire? Just clip the wires to get to a cleaner part of the wire?
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Bilge Wiring

If the wires are smoking I would say it is time to install the proper size fuse. Then see why the pump is drawing so much current. The impeller may simply be jammed.
 

robert.tadefa

Cadet
Thread starter
Joined
Aug 20, 2011
Messages
6
Re: Bilge Wiring

I bought wiring and fuses. All it turned out to be is the pump needed to be replaced. Thanks. Good now.
 
Last edited:
Top