Bilge pump problem

bddliner

Recruit
Thread starter
Joined
Jul 9, 2011
Messages
3
My 1988 Bayliner (Inboard OMC engine) bilge pump is bad. How do I get the base of the pump out. I can't find any screws on the base. Does it screw in? I have removed the top of it. Since I can't find the original pump I have to remove the base also. Any advice would be helpful. Thank you
 

Fireman431

Rear Admiral
Joined
Sep 17, 2007
Messages
4,292
Re: Bilge pump problem

Possible that it is epoxied down if it is in direct contact with the hull. If there is a piece of (painted) wood under it, then it is screwed down. Might just have crap & gunk over the screws or there might be two on the outside (front & rear) of the pump strainer.
 

seabob4

Lieutenant Commander
Joined
Jun 10, 2008
Messages
1,603
Re: Bilge pump problem

Is the pump directly under the motor (like almost all I/Os)? Most pump bases use 4 screws. If you can even get your arm in their, you should feel the heads. If no heads, then I'm betting it was secured with 5200. Is the base circular and red in color? If so, it's a Rule, and a new pump should snap in place...
 

bddliner

Recruit
Thread starter
Joined
Jul 9, 2011
Messages
3
Re: Bilge pump problem

There is a small rise on the hull that it sits on. Its very hard to see since its under the oil pan. Maybe it is epoxied down.. Thanks for the help..
 

bddliner

Recruit
Thread starter
Joined
Jul 9, 2011
Messages
3
Re: Bilge pump problem

The base is white. I bought an rule pump but it would not snap down on it..
 
Top