BF8 Not Sparking

fidobsa

Recruit
Thread starter
Joined
Jul 8, 2008
Messages
4
Alternator is working as you get a glow in the oil warning light when you pull the starter cord. Checked the kill switch and that's working OK. Tried to check the ignition coil but I don't know how it works as there only seems to be one low tension wire. The high tension leads seem to be sealed into the coil so I can't check the resistance of the ht side of the coil. Resistance measured between the single terminal and the engine casing was 0.9 ohms, which seems low to me :confused: I could not see where the magnetic ignition sensor lives so could not check that. Is there any information available online for these engines?
 

fidobsa

Recruit
Thread starter
Joined
Jul 8, 2008
Messages
4
Re: BF8 Not Sparking

Apparently the fault was not with the ignition but a fuel connection. It seems that these Hondas produce such a feeble spark that you can only see it in almost complete darkness. I was using the old technique of taking a plug out, putting the plug cap back on and holding it against an unpainted bit of engine while pulling the starter cord. I do have a spark checker which plugs on between plug and cap but it is for 14mm plugs so would not fit the Honda.
 
Top