Aux. Mount for Electric Trolling motor

hcr32

Recruit
Thread starter
Joined
Jun 9, 2012
Messages
2
Hi everyone!

Just need a little help here. Been searching the net for hours and can't really find what im Looking for.

What it'd like to do is mount an electric trolling motor off the transom of of 14' Princecraft Springbok. It will not mount directly to the transom without the 9.9hp outboard hitting it or vice versa. Wondering if there is some sort of bracket (like a kicker bracket) i could mount on the rear to put the trolling motor on to give it some distance from the outboard.

Here is a picture of the same boat. Only enough room to mount on engine directly to the transom..

(Not my boat but the same transom)

IMG_0774.JPG
 

fishrdan

Admiral
Joined
Jan 25, 2008
Messages
6,989
Re: Aux. Mount for Electric Trolling motor

Welcome aboard hcr32!

If you can attach both of the motors to the transom, I don't think you'll have a problem. I have the same scenario on my jon boat and it's a non-issue. You don't want the trolling motor down when running the outboard for obvious reasons, and when running the trolling motor you don't wan the outboard down as it will cause additional drag,,, you'll go faster and/or use less battery with the outboard up.
 

hcr32

Recruit
Thread starter
Joined
Jun 9, 2012
Messages
2
Re: Aux. Mount for Electric Trolling motor

Hi and thanks for the welcome.

The problem I have is when both motors are mounted and one is up when Im not using the other is that the one Im using will hit the other one when turning etc.

What im thinking of is mounting a kicker type bracket like larger boats have on the rear left of the transom.

Would something like that work or am I overthinking this?

Thanks!
 

fishrdan

Admiral
Joined
Jan 25, 2008
Messages
6,989
Re: Aux. Mount for Electric Trolling motor

What im thinking of is mounting a kicker type bracket like larger boats have on the rear left of the transom.

I have a kicker bracket on my 18'er for the transom trolling motor, but it might be a bit overkill as you were thinking. One of these mounts might be a good compromise, though it's going to put the TM 5-6" further back and make reaching the tiller handle harder.
 
Top