at a loss please help 1980 35 Evinrude

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
Hello I have a 1980 35HP Evinrude that has a good blue spark, 120 lbs compression both cylinders and NO START I have taken out plugs and added a little fuel in cylinder, no start. I cautiously hit it with some starting fluid and no start. I notice oily fuel seeping out weep hole in rear of lower unit just above mounting flange. I am a decent auto mechanic but boats are not my expertise but fuel, spark and compression should do something !
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
I considered that, but did not think it would spark at all with that bad. I remember issues with those on lawn mowers when I was a kid. The smallest deviation would shut down a mower.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
No , No-----This is an electronic ignition.-------A sheared flywheel key and you still get lots of spark.------Just at the wrong time.-----Costs no $$$ to check in my opinion.
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
Your right its a easy check and I will do that tomorrow , like I said I was thinking in terms of lawn mowers LOL Thank you for the advise.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Even on newer lawnmowers with a sheared key you get great spark !!-----------Not so on an old points magneto with aluminum key.----Did lots of those meself.
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
Darn !! I was hopeful I would find a bad flywheel key and to much disappointment it is in perfect condition any new thoughts anyone ?
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Are the spark plug wires on the correct plug? Could the carb be flooding the motor? Does the spark jump a 1/2" air gap?
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
the plug wires are on the correct plugs I will check the spark jumping air gap !
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
Well I took plugs out and did the old Phillips screwdriver test I did not get what I felt was a half inch jump to head bolt. It was a solid quarter and maybe, maybe a bit more. Its a nice blue spark but with this test and using plugs I do not hear the tell tell snap I find in other applications !
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
want to see twice that much, though -- just a cheap open air tester will do.

The plug gap should be .030 (Champion QL77JC4, but check).
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
I just put two new plugs in it yesterday and used NKG equivalent of the Champion QL77JC4 I have ran NKG in my sons 2 stroke race bike with success thought they would be OK in this ? But the two plugs I took out looked very good and they did the same thing and both where the Champion QL77JC4
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Your call. Try closing the gap if at .040, but would grab a $10 tester when you are next in an auto parts store.
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
I did set at 40 and will close them up to 30 I am also going to pick up a tester tomorrow. Any thoughts on what would result in a weak spark if this is the problem ? Both plugs are doing ( or not doing ) the same thing. Visually the spark looks Identical so I would think if there is a problem its before the coils ?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Let's see -- pulling it over with the recoil starter, or using the electric? It may be that cranking faster will give you a better spark. If using the electric, consider charging the battery and cleaning connections.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
jeepman, I don't think I need to tell you this, but that is just an engine. Like any other engine it needs adequate compression, adequate spark at the right time, and fuel in the correct air/fuel ratio. In addition, a two-stroke requires crankcase compression. We can sit here all day and guess, but in the end you have to check it out. Is it possible you have too much fuel? Is it possible you have a cooked engine (badly scored pistons?) Remember you can have compression (rings) and still have trashed piston skirts. Is it possible you have some critter built a nest in the intake manifold? Stuff like that. See what I mean by guessing?
 

Thejeepman

Cadet
Thread starter
Joined
Apr 15, 2017
Messages
9
This boat will not come close to jumping a half inch gap I shortened the plugs and got to fire and run but it quickly fouled I have noticed that the under hood wiring harness it ROTTEN the copper wires crumble as well as the insulation I am beyond belief at how rotten it is. May be the problem !!! I found a new after market on EBay does anyone have any experience with these or can point me to a good supplier.
 
Top