anyone know what size and thread type the outer prop shaft nut is?

[2004 searay]

2000 dp-sm outdrive, i am trying to make a tool and if these threads are a pipe thread, for the inner prop, i may be in better shape than i thought.,

 

[Scott Danforth]

no prop nut is a pipe thread

 

[2004 searay]

no prop nut is a pipe thread

any idea what type of thread it would be ?

 

[jimmbo]

What kind of Tool are you trying to Fabricate?
You can take the Nut, to a Nut and Bolt Supply, and they can measure it

 

[Scott Danforth]

You ha e a DP. The prop nut cone threads on and has an internal lock screw. I think the internal threads are 1-1/16" and the lock screw is 5/16

 

[2004 searay]

i was hoping i oould fabricate a tool to resemble the inner shaft puller tool.

 

[Scott Danforth]

You know the inner and outer shafts come out as an assembly prior to separating them.

 

[2004 searay]

You know the inner and outer shafts come out as an assembly prior to separating them.

no, i didnt. from what i read, that tool screws onto the outer shaft and you use a bolt through the center of the tool to tighten against the inner shaft which pulls the outer shaft and carrier from the case. no?