Anyone have the correct parts diagram and part numbers for a 1965 Johnson LD-10s?

[BWhaler17]

Hello again,
I ordered some parts, drive shaft seal and propeller shaft seal using the online diagrams for a 1968 5hp. Well that proved to be a bad move because the seals are not the same OD. I was wondering if anyone had access to the part numbers for that model. I also made the mistake of not writing the seal numbers down before I removed them. Needless to say I was pretty confident the parts were going to be the same. If not I can try my local OMC guy, He will probably be able to look them up, but not get them.

Thanks
Scott

 

[samo_ott]

Re: Anyone have the correct parts diagram and part numbers for a 1965 Johnson LD-10s?

I have the parts manual fore the '67 5hp (LD-12) but not the '68. dunno how similar they are but I bet they're pretty close. If you want it, PM me your email address and model#

 

[samo_ott]

Re: Anyone have the correct parts diagram and part numbers for a 1965 Johnson LD-10s?

And your local OMC guy should easily be able to look them up and order them. My local guy can look anything up and order most consumable parts back to '57 or so.

 

[F_R]

Re: Anyone have the correct parts diagram and part numbers for a 1965 Johnson LD-10s?

I have the parts list for the 1965 Evinrude version of your motor. Same motor, different hood. PM me your e-mail address and I'll send it to you. Remind me in the PM what you are looking for so I don't have to backtrack to figure it out.

 

[BWhaler17]

Re: Anyone have the correct parts diagram and part numbers for a 1965 Johnson LD-10s?

F_R
PM Sent
Thank You
Scott