Huskerhammer
Recruit
- Joined
- Jul 6, 2020
- Messages
- 2
I have been digging through this forum, and the troubleshooting guides, but failing. Everything works on my trim unit: 1) Runs up & down from the Bow toggle all the time; 2) if I jumper power to the throttle toggle (red wire) the trim pump unit works. The blue & green are spliced into the Bow toggle just under the throttle unit. The Red, Green, Blue become a flat cable and runs to the back of the engine where a 3 Bladed fitting then runs it down to the Trim pump.I cannot find the 10 amp fuse (#15) shown in some VP Trim Troubleshooting schematics. Where is it? Am I missing something else?
2006? VP 4.3 GL-A, Larson SEI19, sterndrive SX, bow trim rocker and throttle trim rocker. Only has trim position sender, not trim limit sender.
Thanks for your patience and assistance.
Eric
2006? VP 4.3 GL-A, Larson SEI19, sterndrive SX, bow trim rocker and throttle trim rocker. Only has trim position sender, not trim limit sender.
Thanks for your patience and assistance.
Eric