alpha one gen 2 top cap bearing

[r_bankston_3]

Hey im new here..Can anyone possibly tell me the number for the bearing and race in the top cap.. mine froze up and i cant read it and i would like to pick one up at a local bearing supply. Thanks..

 

[Don S]

Re: alpha one gen 2 top cap bearing

Not every Alpha I Gen II took the same bearing. So without a drive serial number, you can't even get an accurate Merc PN for one.

I also can't imagine that bearing freezing up and there isn't something else wrong somewhere that you aren't aware of.

 

[r_bankston_3]

Re: alpha one gen 2 top cap bearing

0w562496.. Its a 2006 model 1.81 gears.. The bearing spun... Its was run low on fluid..

 

[ktbarrentine]

Re: alpha one gen 2 top cap bearing

Then you most likely have other drive problems, too...(including metal in the lower gears). just sayin'

 

[r_bankston_3]

Re: alpha one gen 2 top cap bearing

The drive oil that was left in it didnt appear to have any metal in it.. I pulled the the top cap and found this bearing. i removed the yoke shaft, seals, double bearings, and drive gear and driven gear.. all is well except this cap bearing..

 

[Bondo]

Re: alpha one gen 2 top cap bearing

The drive oil that was left in it didnt appear to have any metal in it.. I pulled the the top cap and found this bearing. i removed the yoke shaft, seals, double bearings, and drive gear and driven gear.. all is well except this cap bearing..

Ayuh,... Welcome Aboard,.... Do ya have the manual to shim, 'n set the rollin' torques,..??
The lower should atleast be torn down, 'n Cleaned...

Any ground metal from the upper, falls into the lower....

 

[r_bankston_3]

Re: alpha one gen 2 top cap bearing

Yea i have the manual.. and i have a new set of double bearings.. And im gonna set the rollin torque with an old driveshaft i have..I jus need the number for the top cap bearing so i can purchase it locally.. thanks for the replies guys..

 

[muc]

Re: alpha one gen 2 top cap bearing

32575T1 is the MerCruiser number for the bearing
18-1179 is the sierra marine number ---- Napa can use that number to cross reference.

32563A1 is the shim kit for upper bearing
18-2282 is sierra

35980A1 is the shim kit for double bearing
18-2292 is sierra

I’m guessing you already have the o-rings and seal that you will need.
It would be pretty foolish to not replace them while it’s apart.

 

[r_bankston_3]

Re: alpha one gen 2 top cap bearing

Ok thanks man.. I didnt know the parts store could cross the merc number or sierra number.. i always thought you had to have the number off the actual bearing.. But i thank you.. Thanks for the reps guys