Alpha 1 shifting force

utdcg1

Recruit
Thread starter
Joined
Feb 23, 2008
Messages
5
Have a 1989 Mercruser 3.0L w/ Alpha 1 outdrive. With the shift cable disconnected from the engine, how much force should it take to move the cable? I put a spring scale on it and it moved with 11 lbs of force from the retracted to the extended positions. Is this about normal?

History...got stuck last weekend on the lake with no shifting. Replacing the control module (it broke with a bit too much force applied by a heavy handed skipper...) but don't know if I have another issue with the outdrive...

Thanks in advance for your responses!
 

bacafrog

Petty Officer 3rd Class
Joined
Sep 10, 2009
Messages
97
Re: Alpha 1 shifting force

I just got done replacing my lower shift cable this week. The difference between my old one and my new one is huge. The new one needs very little force for me to move by hand. Were as the old one needed a lot of umph to move it by hand. To me it sounds like 11bs is to much. From what I have read and understand it should move freely with very little to no restriction. Hope this helps out some how.
 

utdcg1

Recruit
Thread starter
Joined
Feb 23, 2008
Messages
5
Re: Alpha 1 shifting force

Thanks for the note...I seem to have after I posted where the control module needs to be able to move a force of up to 15 lbs...so I think I may be close to the limits and need to get the cable changed...better early than late for sure...

Thanks!
 
Top