ac not working

ronald1000

Recruit
Thread starter
Joined
May 31, 2012
Messages
1
I have a 1986 27' Sundancer. Everything worked fine until today. My ac just stopped working. The breaker is fine, and there is enough water coming thru thru the water filter in the engine compartment. When I turn the unit on, nothing happens. The indicator light won't even turn on. I shut the breaker off, let it reset for about ten minutes then everything work fine for about 5 minutes. Then it shuts off again. Has anyone else had this problem? I live on my boat and this the worst time not to have air that works!
 

Fireman431

Rear Admiral
Joined
Sep 17, 2007
Messages
4,292
Re: ac not working

It sounds like you don't have enough water circulating to cool the condenser. Although there is water coming from the pump, even a diminished amount is enough to set off the shut down circuit. The other point is that there is crap inside the coils causing the unit not to transfer the heat to the flowing water and the unit heats very quickly. To trouble shoot it, put it in FAN mode only, which keeps the AC compressor off. If it runs in FAN, but not in COOL, then you need to flush the unit as you have crap accumulated in the coils.

Remove the outgoing waterline from the AC coil. Affix another small diameter hose to the coil and pour in either some bleach or muriatic (pool) acid. Place a garden hose nozzle and open it fully. This should flush the coil and the water line back thru the AC, thru the strainer, and raw water intake. Do this 3-4 times. Then reattach that hose and run the unit. You should see a significant amount of grime and crap come out of the discharge port after restarting the AC.

To protect your AC, backflush & clean annually.
 
Top