A North East hello

Prinothspeeder

Recruit
Thread starter
Joined
May 28, 2018
Messages
2
New to boats and new to the forum with a couple questions.

I curently own a 1982 Johnson 35 #J35ECND, She whent great for a few times out decided I wanted more flow from my impeller so I swaped in a new unit. All was good for a run then the second time out I started having a poping out of gear issue.
it would pop and slam right back in at high throttle but would put around fine.
re droped the lower unit made sure to couple the shift shaft in the proper gear thinking that might cause a hight diffrence, however that did not help the issue it became worse.
I have chaged lower unit oil thinking that could be a cause. There are metal flecks in the oil after flushing with new oil.
Where can I adjust my shift length? I dont see any adjustments. Or is my issue further involved?

Any help would be greatly appreciated thanks in advance
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Make sure the LOWER shift rod is fully screwed into the lower unit.-----Do not turn the lower shift rod when installing the coupling nut.
 

Prinothspeeder

Recruit
Thread starter
Joined
May 28, 2018
Messages
2
Im fairly positive its in there it doesnt move freely when coupling
also if I move the lower shift rod through the gears is seems to shift fine
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Then perhaps the metal bits in the gear oil indicate wear on the clutch dog.----Time to take it apart for inspection.
 
Top