I'm not getting 12 volts (measured at the starter lug) to the fuel pump during the start cycle. If I bypass the low pressure sensor, the pump will start pumping fuel, so my problem is in the starting circuit... how many volts should I see coming off the starter and where to the two purple-yellow wires meet? (one cones from the stater and the other from the oil pressure sensor)... I wonder if I have a bad connection, that's causing the voltage drain.
It's either that or
1) weak starter that's drawing to much current to start the motor, so nothing is left for the fuel pump
2) bad fuel pump, but it runs like a champ on 12 volts
3) the oil pressure sensor, but that shouldn't impact the start cycle, right?
Thanks!
It's either that or
1) weak starter that's drawing to much current to start the motor, so nothing is left for the fuel pump
2) bad fuel pump, but it runs like a champ on 12 volts
3) the oil pressure sensor, but that shouldn't impact the start cycle, right?
Thanks!