97 Johnson 50 HP - Started 1 time after repairs!

itneverends

Recruit
Thread starter
Joined
Oct 21, 2017
Messages
2
Ok, I have a 97 Johnson 50 HP. I replaced the stator, timing base, coil, and power pack. It fired right up. I brought up the rpm a little then backed it down and it stalled and refused to start. Spark jumps the 7/16 gap easily, 160 lbs compression per cylinder. Carbs rebuild in the spring. Fuel pumps tested and works fine. Timing while cranking 4 degrees. Won't start. Makes attempts. Replaced spark plugs same results. Put fuel in carb no start... Put fuel in spark plug hole, still no start. Also changed the fuel. Crank is strong and so are battery's.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
After checking flywheel key....

Take a fuel sample into a clear jar out of the end of the fuel line. Do this even if it is brand new!

Verify that spark leads go to proper cylinder.

Verify that orange with blue stripe goes to top coil.

Answer: has it ever run well since the carbs were done in the spring?

Also, verify that you have spark with key in run position, not just crank position. This is done by installing spark tester. Place key in run position, one click to the right. Use a bump switch to put 12v to the small terminal of solenoid that has the yel/red stripe wire. In a couple very rare cases I have found key switches to be bad in run Position but still have spark in crank position, and vice-versa.

Answer: what position is red lever on primer solenoid in?
 
Last edited:

itneverends

Recruit
Thread starter
Joined
Oct 21, 2017
Messages
2
Thank you... I am gong back to the boat today to check it out again. I will post back and let you all know what I find. Thanks for the help!
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
Did you miss my tag line?... Jake and I threw some questions at you!
 
Top