95 Evinrude 150 Loses Prime at Idle

Ranger371

Recruit
Thread starter
Joined
Jun 14, 2017
Messages
2
Hello everyone, long time lurker but first time poster. I have a 1995 Evinrude 150 intruder that has me stumped. Usually I can diagnose and fix these old outboards fairly easy but this is my first looper. Motor has good compression, between 105-115 across all 6. Motor will run all day when I'm up on plane but when I'm idling through a no wake zone it will run out of fuel after a few minutes. If I prime the bulb back up it runs another few minutes and repeats the process. I started by replacing the primer bulb and checking all my lines/connections for leaks. I found one small leak in the vacuum switch where it has cracked, blocked it off to test while another one is in the mail but the problem is still there. I've also taken the VRO pump off, which is bypassed and just running premix. No hole in the diagphram and the pulse line seems to have good pressure. Sorry for the long post, any help is much appreciated.
 

bob johnson

Rear Admiral
Joined
Feb 25, 2009
Messages
4,306
I wonder if your idle passages are dirty and partially clogged... maybe the pump is barely giving pressure and not enough is getting by the tight passages to match the air coming in....you squeeze the bulb and you give a little more pressure and just enough fuel gets by the dirty idle passages to keep it running..... that's JUST A GUESS..... you have vacuum lines that play a part in this system that I myself don't fully understand... include the main pulse fitting...and its a little complicated......

best of luck hopefully someone with a little more diagnostic experience will come by!
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
The squeeze bulb wouldn't typically cause a problem like that.

​Check for leaks in the fuel line connectors, or anywhere between the fuel pump and tank. Also check the anti siphon valve at the fuel tank.
 

Ranger371

Recruit
Thread starter
Joined
Jun 14, 2017
Messages
2
Thanks for the help. Checked every connection inside the cowl and every connection on the boat. Replaced all fuel line inside the cowl but will replace the line from the boat. I can rule out the anti siphon valve and any problems with the fuel tank itself because I have dual tanks and the problem is still there on both. I'll replace the rest of the fuel line and if that doesn't cure it I guess I'm left with replacing the pump. Is there a non VRO option that doesn't require a ton of modification and does anyone know a part number for it? Thanks!
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,330
Does that motor have a vapor separator and a vapor pump? If so, I would check those as well.
 
Top