95 3hp johnson lower end removal

Mja2305

Recruit
Thread starter
Joined
Dec 10, 2015
Messages
1
I got a 3hp 95 johnson and I am trying to change the impeller but I can't seem to get the lower end off. Took the 2 bolts out but the drive shaft won't disengage. Any help would be appreciated.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
I'll post a guess (will at least get you bumped). My motors are 30 to 40 years older than yours.

If your model shifts into neutral, you will have a shift rod that connects up under the powerhead. Until you remove the powerhead and disconnect it, the shift rod would likely keep the lower unit from dropping.

It would be a good idea to get hold of a service manual for your motor, or at least find a parts blow up. Online, you may get what you need here: http://www.boatinfo.no/lib/library.html And in the meantime, maybe another lister might be able to give some hands on instructions.

Nice little motor!
 
Last edited:

Vic.S

Rear Admiral
Joined
May 4, 2004
Messages
4,721
ITYWF that the shift rod should simply pull out from the gearbox. No need to disconnect it at the top

The problem is most likely that the drive shaft is rusted into the crankshaft .

You could try inverting and getting some release oil down to it .

Eventually brute force may well pull the shaft c/w impeller drive key through the top of the water pump. If its a metal key it'll wreck the cup and/or pump housing on the way.
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
No Title

If it is a 1995 model it shows a shift rod #27 on the diagram.
 

Attachments

  • photo235497.jpg
    photo235497.jpg
    17.4 KB · Views: 0

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
OP seems to have left the building -- would want him to confirm (may have a different model than indicated).
 
Top