94' evinrude outboard wont throttle up

HoldenIron

Recruit
Thread starter
Joined
Aug 1, 2017
Messages
2
My 94' 70HP outboard wont throttle up. My lever is as far forward as it will physically go but the motor wont go above 3900rpm's and about 8 mph. With the motor off and the lever all the way forward I can manually roll the synchronized throttle linkage at the carbs forward another good inch or two...this boat and motor is used and I just got it. What is out of adjustment thats keeping me from throttling up all the way? I tried adjusting the throttle cable length with the wheel you spin both forward and back and it didnt change anything. I really would appreciate any help someone could give me.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Compression and spark test need to be done. Sounds like you could be running on 2 cylinders, to check that do a cylinder drop test . You can make the carbs over travel on those when you move the carbs by hand. Take the airbox off and run the throttle forward to make sure the carbs are opening the way they should.
 
Last edited:

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
^^^^^^^The above as the throttle shafts will roll pass the butterfly horizontal setting.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Inspection and testing needs to be done.-----If spark and compression are good then look inside the motor.------Possibly a cylinder sleeve out of position.
 

HoldenIron

Recruit
Thread starter
Joined
Aug 1, 2017
Messages
2
All three cylinders test strong for compression and all three are firing, New plugs and wires installed. Motor idles good, new temp sensor installed, new grounds installed. Just put in a new water pump. Also just installed new fuel line, pump. Took the gas tank out and cleaned. I purchased a factory service manual off of ebay and after looking at ir awhile and following the diagnostic tree I am lead to believe its a adjustment problem somewhere. I just cant figure out where yet.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Do the carbs open all the way? Have you done the cylinder drop test? What is the compression? A link and sync is a good place to start
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Possibly a cylinder sleeve problem -----Costs very little to check that.
 
Top