93 rude 200hp xp vindicator timing

Zane121

Recruit
Thread starter
Joined
Sep 19, 2017
Messages
3
I go to set the timing and it just ain't right....I've tried several different methods...1. remove spark plugs disconnect w/b wire to temp sensor by #2 cylinder. Plug in spark tester to #1 sparkplug wire. Disconnect carbs from linkage. Set throddle to WOT. With remote starter button in one hand and timing light in other. Making sure the timing advance housing is bottomed out against stop....plug timing light to separate battery...push remote starter button and the timing marks don't come anywhere neer the pointer....in fact it appears somewhere over #1 cylinder....with the stop screw screed all the way out the boat runs about 65mph but I'm afraid I might be damaging my motor....Q....what is the proper way to set the WOT timing.....
 

Zane121

Recruit
Thread starter
Joined
Sep 19, 2017
Messages
3
2. Crank motor up and check timing with everything set as explained earlier except now I have the plugs in and the motor running....with the stop screw screwed all the way out I get 18* BTDC, which is correct but I can't get it to 22* BTDC, 4* under spec, like I read somewhere earlier, which leads me to believe something is wrong w/the way I'm doing it....the only other way is to set it while someone else drives which is dangerous, but I could trust that to be right....
 

Zane121

Recruit
Thread starter
Joined
Sep 19, 2017
Messages
3
In anxious to get out and try out my new trolling motor and fish finder with my son b4 knee replacement surgery Oct 11th 2017
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Make sure the timing light pick up is not hanging down by the other spark plug wires. Joe reeves method of timing usually works the best.
 
Top