'93 Evinrude 90 HP stalls at 4k+ RPM's

BlueFish21

Recruit
Thread starter
Joined
Jun 6, 2011
Messages
1
I have a newly rebuilt 90 hp outboard with rebuilt carbs. Runs smoothly from 0 to 3800 RPM's. After 3800, it will miss badly as if it's not getting enough fuel. The RPM's are all over the place when it's missing/stalling. Once I pull back on the shifter, it runs smoothly again. Recently, we replaced the fuel pump. Diagnostics on electronics checks out. Problem ONLY occurs after engine has been running 5 to 6 minutes. Ideas? Suggestions? Comments?
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Does your horn beep when you turn the key on? You may be going into slow.and not getting a warning tone along with having an inaccurate tach.

Any further testing shall be done with premix in tank. Double oil will not hurt.

Compression test and report back results. Guage cam be rented at parts store. National chain cheap tool store $10 Guage are worthless.

Also get an open air gap spark tester. Set to 7/16" and check each cylinder. Report back.

Report back wether horn sounds when turning key to run position. (One click clockwise)

Did you rebuild engine or a shop?

Have you verified timing?

Who did the link and synch?

When it acts up can you lay your hand on top of the heads? Is it overheating?

Need model number.
 
Last edited:
Top