'93 40 hp Johnson warning horn - no VRO!

Wadester

Cadet
Thread starter
Joined
May 10, 2004
Messages
10
Hi,<br /><br />I have a '93 40 hp Johnson VJ40ELET remote long-shaft - bought new. The VRO connection was removed (a few years ago), so now I mix the oil & gas. After running for a few minutes the warning horn starts making rapid short tones which, according to the manual, means there is no oil flow from the pump. If I turn it off and back on immediately the horn stays off for another few minutes and starts again. This happened last fall after I had a faulty ignition switch box replaced. I asked the shop if this was why the warning horn was acting up and they said it had nothing to do with it. I don't understand why it would come on like that if the VRO has been disconnected. Can I just disconnect the warning horn in the remote control with no bad effects?
 
D

DJ

Guest
Re: '93 40 hp Johnson warning horn - no VRO!

Were the electrical connections to the oil injection also disconnected?
 

Wadester

Cadet
Thread starter
Joined
May 10, 2004
Messages
10
Re: '93 40 hp Johnson warning horn - no VRO!

I'm pretty sure the electrical connections were disconnected when the VRO was removed since I never had any problem till the switch box was replaced. I was thinking that they somehow re-connected them when they did the switch box. I looked for the wire that you are supposed to use to test if the warning horn is working but couldn't find it.
 
D

DJ

Guest
Re: '93 40 hp Johnson warning horn - no VRO!

I think something got reconnected.
 

Walker

Captain
Joined
Jun 15, 2002
Messages
3,085
Re: '93 40 hp Johnson warning horn - no VRO!

What switchbox are you talking about. The key switch?? Its possible the alarm module had been disconnected and when they put the new switch in they reconnected it. Check the VRO and make sure its wiring harness is unplugged
 

Wadester

Cadet
Thread starter
Joined
May 10, 2004
Messages
10
Re: '93 40 hp Johnson warning horn - no VRO!

The shop just called it a switch box. I was having trouble starting sometimes and they checked the ignition and found intermittent spark so they replaced this box (part no. 175316). I will check the VRO connection again, it may have been reconnected.
 

Wadester

Cadet
Thread starter
Joined
May 10, 2004
Messages
10
Re: '93 40 hp Johnson warning horn - no VRO!

Don't know if this will help but the replaced part was the Power Pack - CD2SL267. I can't figure out what the VRO electrical connections are. Any ideas?<br />Anyway, even if they are left connected would disconnecting the warning horn be okay or is it used to warn about other conditions, like over- heating?
 
D

DJ

Guest
Re: '93 40 hp Johnson warning horn - no VRO!

Follow the fuel line into the engine. It is connected to the VRO pump. The pump was not removed, most likely, just disconnected. <br /><br />You will see several wires coming from that pump. They SHOULD NOT be connected to anything. If they are, unplug them.
 
Top