92' 35hp johnson 2-stroke bogging

ksfowler27

Cadet
Thread starter
Joined
Oct 18, 2011
Messages
12
I have a U.S. Marine Corp. Jet pump i purchased from the state. I believe they call it a Jet Pump or Durajet. Anywho, it idles great but as soon as i get to quarter throttle or higher it boggs out. I noticed another thread on here that was having the same problem. I am currently running NGK spark plugs and have been hearing rumors that i should be runnning champions? is this true? will this effect perfomance? Also, was told that the gasket could be falty and could be allowing air to suck in and not allow fuel to flow properly. Any thoughts would be great. I have thoroughly cleaned all fuel lines and fuel pump and screen. Plan on getting a new carb kit today and cleaning the carb but was curious if there might be something im missing. Any thoughts or ideas?
 

SparkieBoat

Captain
Joined
Aug 17, 2009
Messages
3,643
Re: 92' 35hp johnson 2-stroke bogging

the correct champion plugs are best...but your performance problem is almost certainly a clogged carb(s)..follow the instructions in my sig below.
 

ksfowler27

Cadet
Thread starter
Joined
Oct 18, 2011
Messages
12
Re: 92' 35hp johnson 2-stroke bogging

Ok update... I took it out and ran it with new correct spark plugs in and thoroughly cleaned carb. I can still only get to about half throttle. Once i throttle above that it will start bogging/choking so to speak. It gets a cough or poping sound as i go above half throttle. Could this be possibly the timing? Also, i did replace the fuel hose from tank to motor. Old one was rough looking on the inside of the hose. And one last thing, i checked the compression on both cylinders and got a 126 on top and 125 on bottom. Any thoughts?
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: 92' 35hp johnson 2-stroke bogging

It could also be an ignition miss. Put a timing lite on it and look into it when this happens and see if you see any black spots. This would indicate an ignition miss.
 

ksfowler27

Cadet
Thread starter
Joined
Oct 18, 2011
Messages
12
Re: 92' 35hp johnson 2-stroke bogging

Ok im pretty new at this outboard mechanics but when you say " look into it" do you mean directly at the timing lite as its running to see the skips in firing? also it runs great up until that half throttle or more position. And im pretty sure it's missing being the little spudders i get every now and then when at half throttle. The spuddering does get more aggresive the more i throttle up until finally dying. Anyone have an idea how exactly to check the timing on this motor to see if it's correct and to do so do i need a timing gun?
 

ksfowler27

Cadet
Thread starter
Joined
Oct 18, 2011
Messages
12
Re: 92' 35hp johnson 2-stroke bogging

Well i decided to take a step back and just run through the motions of things to make sure every thing mechanically was functioning correctly and i found this.gap.jpgthrottle fix.jpg Part of the shift linkage was rubbing and stopping this lever to to reach the max timing screw. I apoligize in advance b/c i'm sure those aren't the correct terms for the parts but i'm learning as i go. I am going to work on this and take it out this evening again and see if this fixes the problem. Any comments or ideas are greatly appreciated. thanks
 

ksfowler27

Cadet
Thread starter
Joined
Oct 18, 2011
Messages
12
Re: 92' 35hp johnson 2-stroke bogging

Well just got back from the lake and indeed that was the problem. Ran perfect!
 

nwcove

Admiral
Joined
May 16, 2011
Messages
6,293
Re: 92' 35hp johnson 2-stroke bogging

check the plugs for the correct brownish color after a good run.......just to make sure it aint running lean. (congrats on the the trouble shooting!!!)
 
Top