90hp Johnson 2004 Installation

CAMBO1929

Recruit
Thread starter
Joined
May 13, 2018
Messages
4
Hey guys I've recently purchased a Johnson 90 motor and I'm struggling to figure out;
1. Exactly where the battery cables attach
2. I've found a fried/ burnt wire and wondering if there could be a serious issue with the trim and tilt.
3. The fuel, piping and vapour lines around the motor I'm not 100% sure on
would love some guidance please!!!
 

Attachments

  • photo290415.jpg
    photo290415.jpg
    818.5 KB · Views: 0
  • photo290416.jpg
    photo290416.jpg
    976.3 KB · Views: 0
  • photo290417.jpg
    photo290417.jpg
    770.3 KB · Views: 0

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Red battery cable goes to one side of the solenoid under the starter.----Black should go to ground on the block.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,328
To add to Racerone, the battery side of the starter solenoid is used for multiple hot wires to run the ignition trim and other items that are hot at all times.

Check all the wiring for melted or burned wiring. On a similar motor, I had melting on the boat harness where it connects to the engine harness on the port side, as well as the trim gauge wiring under the dash.

A factory service manual will tell you the routing of the vacuum and fuel hoses. The airbox should have a vacuum/fuel tube on top starboard (slip fit into airbox), and the lower port side will have a vacuum/fuel hose nipple.
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,328
one more thing, negative battery cable bolts to block near starter solenoid.
 
Top