Partonjoshua
Seaman Apprentice
- Joined
- Jun 27, 2016
- Messages
- 49
I have a 2.4l 175 that has water droplets on all 6 plugs and cant figure it out. The pistons look like they have been steam cleaned. So far i have replaced both head gaskets and replaced the divider plate and both gaskets. Checked compression this morning and all 6 are between 118 and 122. Any other ideas, dont think it is a cracked block because i recently pulled the powerhead and replaced 2 pistons, rings, and bearings and it did not have any sign of water in the cylinders before this. Will the adapter plate/ base gasket cause this? Thanks