89 bass tracker tx17 tilt problem

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
89 bass tracker tx17 my tilt will go up but will not go down. same thing if using the trim switch will go up but not down.any ideas as to where i should start to look?
 

Bondo

Moderator
Staff member
Joined
Apr 17, 2002
Messages
71,545
Re: 89 bass tracker tx17 tilt problem

Ayuh,... Welcome Aboard,...

What motor,..??
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: 89 bass tracker tx17 tilt problem

Does the trim motor run or are you saying nothing happens (no clicks, no trim motor running)?
 

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
Re: 89 bass tracker tx17 tilt problem

up works fine but down dosent work...... no noises no clicks no nothing
 

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
Re: 89 bass tracker tx17 tilt problem

could it be a bd wire some where???
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: 89 bass tracker tx17 tilt problem

could it be a bd wire some where???

See how these little details help us help you? Yes - it is definitely a bad connection, switch or relay. Unless you have a voltmeter or test light and know how to use it you will need help. You know the switches are not the problem since the system works in the up direction. Look at the engine and have someone operate the UP trim. You can hear and feel the relay for that function. If the motor has a down relay (some do -- some don't) then compare the number on it with the number on the one the up relay. If they are the same, exchange them. If the trim now works in the down position but not up you found the problem. Replace the down relay. If the system still works only in the UP mode, you have a wiring problem. Disconnect, clean and reconnect all trim system electrical connections. It is also unlikely the motor is bad.
 

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
Re: 89 bass tracker tx17 tilt problem

yes i have both test light and volt meter. i check this morning and getting 12 volts to relay. I jumped the relay and tilt went down. BUT i am getting constant 12v at 1 of the down terminals but not on the up relay at the same terminal.
 

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
Re: 89 bass tracker tx17 tilt problem

(Where can I find) a wire diagram for the tilt/trim????
 
Last edited by a moderator:

JB

Honorary Moderator Emeritus
Joined
Mar 25, 2001
Messages
45,907
Re: 89 bass tracker tx17 tilt problem

Everyone who has an OEM Service manual has the wiring diagram. You need one. Please remember that we do not allow solicitation of private transactions in the forum.

In my limited experience with PT&T that go up, but not down, has been that they are sometimes low on fluid.
 

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
Re: 89 bass tracker tx17 tilt problem

yes i need one was just asking where i can get one.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: 89 bass tracker tx17 tilt problem

You should always buy the factory service manual for your specific engine. The engine manufacturer produced the engine and the manual so its accuracy and level of detail is much better than the aftermarket type which often cover many engine sizes. Some folks really have a tough time following them. So you get a Mercury service manual at a Mercury dealer or you might try E-Bay or you can stop by your local library. They often have service manuals for outboards. While they may not have one for your exact engine, wiring for any given HP may be the same over a number of years. Remember, the relays need to do two things. Carry high current as well as reverse the motor. So you will not likely find the same voltage on the same terminal on both relays.
 

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
Re: 89 bass tracker tx17 tilt problem

the problem is that there is 12v at te green/white wire at the switch that runs to the relay for the down tilt. the blue wire for the up tilt does not have constant 12v, so i am thinking its going to be a wire problem. I was just asking if anyone knew where i can get a wire diagram for the switches. would it be from mercury or tracker?
 

RRitt

Captain
Joined
Mar 30, 2006
Messages
3,319
Re: 89 bass tracker tx17 tilt problem

if you have relays then unplug the relays and swap them. if your problem reverses then you have a bad relay.
 

eldoark

Cadet
Thread starter
Joined
Dec 15, 2011
Messages
21
Re: 89 bass tracker tx17 tilt problem

replaced down relay and now it works great....... Thanks to all for their input.:D
 
Top