88 johnson water pump ?

Rinzler

Recruit
Thread starter
Joined
Jul 8, 2017
Messages
1
Hi... I just finished rebuilding my pontoon and finally got my engine running. My question is this. After finally getting the motor to start, with the ear muffs attached I noticed that water was not shooting out where the little nozzle is. My neighbor told me there is a thermostat and that water will not shoot out until the thromostat opens? I thought that water was supposed to shoot out the entire time. I would rather not cook my engine so I stopped and found this forum and am asking for any kind of input that you more experienced gentleman may have.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
You're right re. the tell tale (neighbor's advice is incorrect). Not necessarily serious, though. Tell tale could be plugged, and running on muffs doesn't test cooling system very well. If you dip the l.u. in a barrel about half way up the shaft, you might find it works. Check temp on the top of the head -- too hot to touch is too hot. An infrared gun is a good idea. Running temps should be well below 160F -- depends some on the water temp in the barrel or lake. I think the temp goes way down on your motor at speeds, maybe 120F or so -- wait for more advice.

Run some line from a weed whacker into the outlet and see if that clears any blockages. And you may be due for an impeller change -- definitely need that if the motor is new to you.
 
Top