87 evinrude 70hp compression?

sswallace

Cadet
Thread starter
Joined
May 27, 2016
Messages
7
I have a 1987 evinrude 70hp. I bought it about a week ago and the guy said it had a scorched piston. I had it starting but wouldn't stay running more than a minute or two no matter what I did. I tore the carbs down and cleaned them " they were pluged " apon a compression test I found 90 psi on all 3 cylinders. Now I am not a 2 stroke guy! Give me a chevy, ford or dodge and I can fix it so i'm in the learing process here. Is 90 adequate? When I say 90 on all three I mean exactly 90 on the gauge. I thought these were supposed to have like 140?? I have a manual but cant find where it says what it should be.

Any help would be greatly appreciated.
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
You say it starts and runs for a minute or two. Is the water pump working? Maybe you need to remove the exhaust baffle cover to look at the cylinders, pistons and rings.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
You won't be able to see anything on that one by taking the exhaust baffle off. Get a different gauge and recheck the compression 90 is to low If the compression is still low pull the head. 120ish is normal anything over 100 should run. I have an 1988 in my garage right now that runs beautifully at an idle compression is 110-120. I pulled the head and the block is going to get resleeved because it's .030 over already and 2 cylinders are junk.
 

sswallace

Cadet
Thread starter
Joined
May 27, 2016
Messages
7
rechecked compression with another tester and still 90. But it seems weird they are all at 90
 
Top