86 JOHNSON 15HP COOLING PROBLEM

svlmustang

Recruit
Thread starter
Joined
Jul 15, 2003
Messages
1
Hello,<br />I bought a 86 15hp, well I took it out in the river and ran it wide open for about 5 minutes. I noticed that it seemed to be running worse and worse. I stopped and checked and the motor was so hot it was melting wires. It pumps water, I removed the Thermostat, and I also installed a new impeller and head gasket. I fired up the motor and it still runs hot. The inside looked pretty dingy. Could this cause the engine to still run hot?? I think the motor was run in saltwater and not cleaned. Are there any easy ways to clean this corrosion out of the powerhead. Please email me with any suggestions or help. Thank You All in advance
 

Solittle

Fleet Admiral
Joined
Apr 28, 2002
Messages
7,518
Re: 86 JOHNSON 15HP COOLING PROBLEM

Did you take the cap off of the head? A lot of crud can get trapped there. You may also have to pull the exhaust cover and go after the water passages there.<br /><br />A dingy looking outside has no bearing on the cooling.
 

Xcusme

Commander
Joined
Apr 21, 2003
Messages
2,888
Re: 86 JOHNSON 15HP COOLING PROBLEM

How did the old impeller look?? Did it have any missing 'arms', you may have a blockage from an old impeller along with the salt builduup. Drop the lower unit, remove the thermostat and connect the water tube to a garden hose and flush the power head. When you have the head off, do some scraping of the passages around the cylinder walls too. You can buy SaltAway solution and idle the motor in a small test tank too to dissolve the salt.Just because you're motor is 'peeing' doesn't necessarily mean there's sufficient water flow to cool things down.<br />BTW, did you check the thermostat while you had things apart?? If it's not fully opening, things will get hot in a hurry.
 

clanton

Rear Admiral
Joined
Jul 9, 2001
Messages
4,876
Re: 86 JOHNSON 15HP COOLING PROBLEM

Remove the powerhead, replace the upper water tube grommet.
 
Top