85hp force no manual yet and need sequence and torque on head

[Smokepole27]

About to get the new head and need a torque sequence and torque specs. I havent gotten my book yet....Im pretty sure the motor is an 89 year model maybe a h0858x89h. Only determination on model is looking a different part sites....

 

[Smokepole27]

Re: 85hp force no manual yet and need sequence and torque on head

Anyone? Getting the head today and am going to try to install tonight.... Please?

 

[ambrowns]

Re: 85hp force no manual yet and need sequence and torque on head

I haven't looked for the answer to your question but if you navigate through this site it will have the clymer service manual for all force motors.

http://web.ebscohost.com/serrc/sear...c5b85-8bfe-4fe6-ac27-f5cef82d6485@sessionmgr4

 

[wickware]

Re: 85hp force no manual yet and need sequence and torque on head

Ideas:

1. Call or e-mail the head provider and ask if they will provide the torque and sequence with the head.

2. Run some searches at this site for the info. There was a head and sequence poster last week or so that might be yours. I saw related info at this address: http://forums.iboats.com/search.php?searchid=6538557
(from a search:"Force head torque sequence").

3. Just guessing, would the average dealer of your motor share this info?

Good Luck!
Jow

 

[BuzzStPoint]

Re: 85hp force no manual yet and need sequence and torque on head

We need a clearer Model number.

If your Model number is:
858 H0

Then you have a:
1980 Chrysler 85 horse

(Assumtions: Model 858 is pointing to 1980-1981 with H0 and H1)

If I got this correct. Here is your torque specs

 

[Smokepole27]

Re: 85hp force no manual yet and need sequence and torque on head

Awsome thanks alot! Got the head on, little iffy about the top left side, some of the gasket is showing ( which is fine) but wiggles a little bit.
Got the new water pump kit and while torqueing down the houseing it cracket so used the old one and while installing to the OB I broke the houseing for the water tube.......... So quick question for those looking at this thread again, any suggestions to reinstalling the foot easier? I can see that I was haveing trouble with the shift rod going back in that tiny hole...
Trim the motor up? All the way up??

 

[BuzzStPoint]

Re: 85hp force no manual yet and need sequence and torque on head

That I don't know.

But here is a service manual if you need it.
"Check your Private messages"