'84 evinrude 75hp carb enrichner nipple

[sutor623]

Let me start off by saying SON OF A ! Anyways I broke this little guy off during a decarb and I'm not sure if or where to find it on this diagram! Any ideas guys? I think the nipple is bronze.



Evinrude Carburetor Parts for 1984 75hp E75TLCRD Outboard Motor

 

[boobie]

Re: '84 evinrude 75hp carb enrichner nipple

What in heck did you do that for ??? I just looked at some parts break downs and it's part of the upper carb body and no part # is shown for it. It's just pressed into the body. You could call BRP customer service at 1-262-884-5993 and maybe they could come up with a # for it.

 

[sutor623]

Re: '84 evinrude 75hp carb enrichner nipple

Man because I'm an idiot! I JB welding it at the moment because JB is gasoline resistant. Since its the enrichner I think it will be fine. If not ebay carb here we go!

 

[phillnjack2]

Re: '84 evinrude 75hp carb enrichner nipple

Just put a bigger pipe on it, then put the normal pipe inside that, its not realy much of a problem as you have
enough metal there to just simply put a pipe on it and small clamp as well.

not much of a problem realy, and to get it out might be a big problem if it snaps half in half out !!!!!!!!!

this just calls for bit of bodgeneering.


phill

 

[sutor623]

Re: '84 evinrude 75hp carb enrichner nipple

I'll get a pic up tonight. I JB'd it yesterday and it is holding up very well. That stuff is a life saver, if you use it for the proper application. I wouldn't use it to seal up a block like some crazies have done in the past!

 

[boobie]

Re: '84 evinrude 75hp carb enrichner nipple

Sutor, the part # for that nipple is 327706 and sells for $6.60. Go to any BRP Dlr or maybe here on I-Boats.

You have a PM.

 

[sutor623]

Re: '84 evinrude 75hp carb enrichner nipple

You da man, as usual!! Sure glad I dont have to replace the carb!! Now, how should I go about removing the old nipple?? Heat maybe?