83 Evinrude 25 hp electric start

ulsterman50

Recruit
Thread starter
Joined
Mar 17, 2018
Messages
3
bought this engine last fall, owner said it was cold blooded so over winter I rebuilt fuel pump, water pump, carb and put in a new ignition brain. Started it today and it runs fine at full and 1/2 throttle but won't idle. When running, the Choke needs to be 1/2 open, open full and it stalls. I like fooling around with engines so really don't want to take it to service pro. I set the float drop with a ruler, but didn't have the special float tool. Have I got a float issue? I did order the special tool and plan on taking the carb back off and using the float tool. Adjusting the slow idle needle doesn't seem to help, it just wont run a slow speed and does jump around quite a bit. Seems to me its too lean, but only adjustment I have is the low speed needle.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
No such thing as " cold blooded " with one of those motors in good condition.----Post the results of a compression test first.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If you have confirmed good compression and spark, sounds like a carb issue. I would concentrate on the idle passages at the top of the carb -- disassemble, soak and spray out with carb cleaner.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Were you running it on a boat, on the lake when you say it ran at full throttle? Did you inspect the high speed jet (orifice plug)? It must be absolutely CLEAN. If not, you have to choke it.

Is the carb throttle butterfly closing all the way?
 

ulsterman50

Recruit
Thread starter
Joined
Mar 17, 2018
Messages
3
initial start up was in the driveway with motor in a barrel of water. I've decided to go back to work on the carb and reset float. I'm dumping the old gas tomorrow at the recycling center and starting with fresh gas. I will check compression as well. Another question though, with the electronic ignition, is it necessary to do a timing adjustment or is that control by the brain as in a car?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The " brain " as you call it is a simple device.-----It does NOT control the timing.----Timing is controlled by the flywheel key and the sensor coil on the magneto plate.-----The " brain " is merely a switching device on that motor.---Timing on that motor does not normally need adjusting.----Only when someone goes adjusting things without knowing does timing go out !!
 

ulsterman50

Recruit
Thread starter
Joined
Mar 17, 2018
Messages
3
I have the carb off again, and the float gauge is arriving tomorrow. I plan on checking the float settings and putting the carb back on. I did determine that the butterfly valve was not opening all the way at full throttle and adjusted that. Dumped the old fuel and will try starting it again on Friday with fresh fuel. In reading the repair manual, I see how the high speed timing is set and will try to set that when I have the boat in the water; what a pain its going to be, running down the lake at full sped, holding a timing light. There's got to be a better and safer way to do that...
 
Top