"81" J70ELCIM

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
OK so first I will list the the things I have done to this 70 Seahorse which resides on my Whaler Classic Sport 15.

Empty/clean gas tank
New fuel lines all around
New fuel pump
New filter
Rebuilt/cleaned carbs (all three)
New starter
New solenoid
New plugs(all three)
New thermostat
New water pump

Push in choke and turn ignition, motor fires once real quick, turn ignition (without choke) and engine
will fire after around 2-5 seconds of the starter turning, I may have to do this a few times before it quits coughing and throwing a mild backfire through exhaust, then it will idle and function normally as far as I can tell.

Turn off and it fires back up beautifully with just a mere tap of the ignition.Turn off and let it sit for a short time and its back to the sluggish cranky start.

Out on the water it's the same scenario for starting except for the bogging down on throttle and idle. After some frustrating bogging and restarting it magically kicks to life and its off to the races! For reel, its amazing! it goes and goes, WOT, MOT, idle, rev. no problems, cruise the bay at various speeds for an hour and again no problems, no noticeable variations of engine functions.
Turn off for a minute and restarts like a champ with just a tap. Let it sit for a drift across the channel (approximately 10-15 min) and its back to the hard start and sluggish idle that bogs out and quits on any attempt at throttle. After a frustrating rematch with this hard start behavior its back to the races, all day if I wanted.

Notes.
No noticeable water on plugs

When engine is in tilt position a small amount of what seems to be thin mix oil seeps from carb over time.

Fuel system seems to be working from tank to engine, firm bulb that does not collapse.
 

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
It does not seem to be sticking.

This morning on a cold start it coughed a bit, smoked a bit, died after a few seconds maybe 10.

Restarted fairly easy with the addition of a bit of feathering on the choke twice.

One thing i did last night was adjust the idle up a tiny bit.

It did seem to start easier this morning on the muffs than it previously has.

This advice is treasured so Thank You
 

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
20 min later it started up with just a turn of the ignition.

This is different behavior than previous.

Could this issue be as simple as an improperly adjusted idle?

Speculation,

When I rebuilt the carbs all three had different kits or levels of rebuild from previous owners. Bottom carb looked to be very old gaskets, they crumbled literally to pieces. This carb had major blockage of different debris.

The top two carbs had newer gaskets but obviously at different times and very little residue or debris.

I am wondering that over time the previous owners may have fiddled around with spark gap,(bottom plug was way off), and idle instead of properly cleaning system of old fuel lines, gas, ect.

I will take it to the launch today to find out if this new behavior applies under load as well.
 

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
Well just for good measure I hooked the muffs back up for one last check before I head to the launch and it gave me a hard cranky start....dang!
 

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
My throttle control has no fast idle arm that I can tell, no buttons,just neutral, forward and reverse.

I do use the choke especially on a cold start.

Am I possibly flooding it somehow with my starting procedure? It sure does act like it is flooded.

PIC is of bottom plug, new two days ago.
 

Attachments

  • photo294911.jpg
    photo294911.jpg
    154.4 KB · Views: 0

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
There is a button after all, a broken unmovable button.
 

Attachments

  • photo294912.jpg
    photo294912.jpg
    590.8 KB · Views: 0

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
Put the boat in the bay, same thing, cranky sluggish smokey, backfire start,eventually it idles up and runs circles around the bay.

Ill post vid of the crazy sluggish start in the morning.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If you don't have a warm-up lever on your remote, don't you have a lock out to allow you to run it at fast idle in neutral? (One of the single lever remotes I have pulls out at the base to allow throttling up in neutral.) If that red button under the grip isn't for trim adjustment, maybe your set up allows you to throttle up in neutral, using the button to shift into gear(?) Anyway, you get the idea -- should be a way.
 

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
Thank you in leagues oldboat1 !!

The red button is defunct and I am unsure what its purpose is/was. Maybe it used to need to be pushed before you could engage motor, whatever the case the button is in permanent engaged position.

The control lever does indeed pull out from the remote so you can throttle in neutral. It really seems to be the missing part of my puzzle.

I will give this a try today.
 

Kelpline

Cadet
Thread starter
Joined
Jul 4, 2018
Messages
10
Experience and wisdom are priceless.

Thank You for sharing yours.

It got it 100%!

This eves Halibut dinner is definitely in honor of oldboat1, flyingscott, and the rest who make this forum a reality.
 
Top