79 Johnson 70hp Engine Dying at higher speeds

jzwatkins

Cadet
Thread starter
Joined
May 17, 2016
Messages
6
Hi, I'm the new owner of a 1978 Marquis with a 70 HP Johnson 70EL79. I took it out the other day, and on my first outing it did great, and I opened it up and it had good speed and the engine sounded great. I docked it for a while and then took my wife out later, but the engine kept stalling. I used a little starter fluid, and it started back up and ran good. We went to open it up more, and then with the throttle up higher it died. After that it was difficult to keep it started. I should add that the previous owner told me he had problems with starting occasionally, and usually keep the carb cover off to make it easier starting with starting fluid. Once running it usually runs really good. I have had it going several times now. I'm going to start with the carbs, especially since he has had problems starting it before. Any other ideas?
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
1) Don't use starter fluid as it has no oil - instead spray oil/fuel mix
2) Hard starting - check the choke plates are operating properly, and that you're raising the fast idle lever
3) High-throttle loss of power - check primer bulb has the outlet side higher than inlet, and that it doesn't go flat when the engine is running. Pumping the primer bulb might bring the power back. If so, check fuel pump and hoses for leaks.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Check the gaskets in the carb seams. If they're black, then the carbs have likely never been apart and would likely benefit from being removed, disassembled, cleaned, and rebuilt with new, ethanol resistant carb kits. Also, if the present internal hoses leave your hands black and smudged if you touch them, replace them, too.
 

jzwatkins

Cadet
Thread starter
Joined
May 17, 2016
Messages
6
I didn't even think of the primer bulb. It has a pretty long fuel hose, and it could've gotten flipped around since there is so much slack. I'm going to give the engine a good cleaning, probably a carb rebuild, new spark plugs, and replace the lower unit's oil.
 

jzwatkins

Cadet
Thread starter
Joined
May 17, 2016
Messages
6
Or possibly have enough fuel left in the line to run long enough to shut down like it did.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
If you have a plastic fuel tank then check the inside of the tank.----Pick-up hoses are known to fail.
 

jzwatkins

Cadet
Thread starter
Joined
May 17, 2016
Messages
6
Just as an update, I have found several interesting things. First, I do not think the gas tank was properly venting, I opened it up and it had a terrible vacuum in it. Secondly, several wires on the engine were very loose, including the wire to the ignition solenoid. The last thing was the spark plugs. They were not even the correct spark plugs for the engine, they were lawnmower spark plugs and the first one had totally failed.
 
Top