78 Evinrude 200- revs too high

drdpets

Recruit
Thread starter
Joined
Jul 4, 2003
Messages
2
Just put new gas in the boat, 12 gals reg, added one quart 2cycle oil. started the boat the the next day (it always takes a few turns of the key) but it started. Trimmed it all the way down of course into the water. After about 5 minutes of full throttle running fine the engine RPM's jumped as if the engine came out of the water and I slowed and shut it down. Now when I run it it runs fine very slow but as soon as I give it gas i can feel and hear the prop not spinning right. I hit a bit of mud when I was taking it out but nothing major, I have done worse in the far past with no problems. Could my hydralics need more oil. Last season the trim needed a lot of new oil, it leaked out I guess but this year it seemed fine. I have ran the boat all last weekend and no problem. Also I had about 5 of big guys in the boat today so it was weighted down pretty good. But not sure why the engine is "over-reving" The prop is tight no play so I don't believe I tore it( I have a stainless steel prop, yea I gotta put on the aluminum one I know...) any clues?
 

Fouled Plug

Ensign
Joined
Jun 29, 2001
Messages
935
Re: 78 Evinrude 200- revs too high

Sounds like it could be a spun prop hub. Scribe or paint a line from splines to prop body, then run up to power a few times. If the lines don't match afterwards, off to the prop shop!
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: 78 Evinrude 200- revs too high

DrD,I'm going with a spun prop hub.Closely inspect the fit between the prop barrel and pressed in center hub and see if there is indication that it has rotated.If you can't tell by looking,make a scribe mark between the prop barrel and the center hub and see after a short run whether the marks have moved.<br /><br />Edit: Fouled plug beat me to it.
 

jim dozier

Lieutenant Commander
Joined
Jan 8, 2003
Messages
1,970
Re: 78 Evinrude 200- revs too high

I vote for a spun prop hub, just happened to me just like you. I hit a little sand, I've done worse, took off like a rocket and bazzingg. Age, bumps, rubber, metal= bazzingg! $40 good to go.
 

drdpets

Recruit
Thread starter
Joined
Jul 4, 2003
Messages
2
Re: 78 Evinrude 200- revs too high

Thanks for the info, that is what I thought too. I will check it today as I have more time than I did yesterday.
 
Top