76(i think) johnson outboard ignition/key switch wiring

pilgor

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
5
hi there i need some help wiring an ignition/key switch for a johnson 35hp outboard motor. it has a throttle and steering wheel. so the two black wires are connected to the throttle. the rest are connected to the motor. then the switch is push to choke 6 terminal. ill upload pics so its easier for people to help me. thanks
 

Attachments

  • image1.JPG
    image1.JPG
    133.4 KB · Views: 0
  • image2.JPG
    image2.JPG
    80.5 KB · Views: 0
  • image3.JPG
    image3.JPG
    115.6 KB · Views: 0

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Did you check out the original factory parts website: epc.brp.com? Keep in mind, the parts you are after may not have been sold as part of the actual engine. When you get out to the 76 parts lists, you may need to go into a special section called "accessories" This is usually where this misc stuff is located.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Assuming it really is a 1976---
Red = Battery
2 blue or 1 Blue and 1 Blue/white stripe = 2 "M" terminals (doesn't matter which one)
Purple/white stripe = Choke (I can't distinguish which is purple in you picture)
White = Start
ACC terminal not used unless you have some accessory like a tach or fuel gauge, etc that only works with key on.

I have no idea what the black ones are for. Please explain how they are connected to the throttle.
 

pilgor

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
5
throttle and setup pics
 

Attachments

  • image1.JPG
    image1.JPG
    130.2 KB · Views: 0
  • image2.JPG
    image2.JPG
    124.3 KB · Views: 0
Top