73 Johnson 40 HP Overheating?

hamz

Recruit
Thread starter
Joined
Jun 29, 2003
Messages
4
Question for you guys. I just purchased a 1973 Johnson 40hp, had the lower end gaskets replaced (leaking) and a new impellor replaced as well. I put the engine in a BIG bucket of water, and ran it at idle. My questions are, how can you tell if the water is circulating inside? I heard that my model didn't have a stream of water that came out of it. Mine did not have an water coming out of the rear, when it sat at idle, so I want to make sure when I go out on the water, that it won't overheat. So can anybody tell me how to check if it is properly circulating, i.e touching the heads, water spraying....thanxs!!!
 
D

DJ

Guest
Re: 73 Johnson 40 HP Overheating?

hamz,<br /><br />You should get a "spray" from the exhaust relief port (top of exhaust housing).<br /><br />Touch the top cylinder head, while running. If you can hold your fingers on it for a few seconds, it's OK.
 

hamz

Recruit
Thread starter
Joined
Jun 29, 2003
Messages
4
Re: 73 Johnson 40 HP Overheating?

When it is idleing in a garbage can of water the cylinder walls are "way" to hot to touch. Remeber the boat is not in the water. And from the release hole, there is no spray what so ever. Is it possible the mechanic put the impellor in wrong? Thanks!!!
 

hamz

Recruit
Thread starter
Joined
Jun 29, 2003
Messages
4
Re: 73 Johnson 40 HP Overheating?

Oh also, you said...<br /><br />"Touch the top cylinder head, while running" The top as opposed to the bottom? When you say the head, I'm thinking the wall of the cylinder wall right beside the spark plug area.
 

Paul Moir

Admiral
Joined
Nov 5, 2002
Messages
6,847
Re: 73 Johnson 40 HP Overheating?

It's possible there's something wrong with the impeller installation. If the key fell out the driveshaft would spin, but not the impeller. Or perhaps the tube leading from the pump to the impeller didn't connect.<br />You ought to be getting _some_ spray. Don't run the engine until you solve the problem.
 
Top