73 85hp Starflight Evinrude Cooling water exit

Lousbert

Recruit
Thread starter
Joined
Jul 1, 2003
Messages
2
Hi I got 73 85hp Starflight Evinrude last year with an 18 ft Starcraft for some short money last year Not even knowing if the outboard ran. The guy that sold it to me told me it did 2 years ago To make a long story short the outboard ran fine the firt time I took it out but I did not see where the water exited from the motor. Is it below the water line? does it have a T- stat? Should ther be a strean comming from the back ? any info would be appreciated.
 

wayne h

Master Chief Petty Officer
Joined
Apr 29, 2003
Messages
862
Re: 73 85hp Starflight Evinrude Cooling water exit

if it has been sitting for 2 years you need to change the waterpump even if it is pumping. i dont think these engines have a pee hole above the water line thats another reason to spend the 15 bucks and get a water pump.yes they have a thermostat also. if you dont have a manual get 1 i would not touch an outboard without 1
 

Lousbert

Recruit
Thread starter
Joined
Jul 1, 2003
Messages
2
Re: 73 85hp Starflight Evinrude Cooling water exit

Hey Wayne Thanks I have a manual & parts catalog on the way. Is it the water pump difficult to change?
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
Re: 73 85hp Starflight Evinrude Cooling water exit

Lousbert.... Make sure that the overheat warning system is operating as follows.<br /><br />Have the key in the ON position. Locate the TAN overheat sensor wires that you will see protruding out of each cylinder head. Slide the rubber insulating boot back, then ground out thhe wire connector to ground (the powerhead).<br /><br />The warning horn that's situated in the control box (or under the console, whatever the case may be) should sound. If it does not, find out why as that's the only warning you'll receive if the engine ever overheats... The alternative is having the engine suddenly seize up into an expensive overhaul project.
 
Top