71 Johnson 60HP Engine - weird problem with cover

PixelsGlastron

Recruit
Thread starter
Joined
Apr 22, 2016
Messages
5
Was having problems running getting my engine to run at idle/any other gear.

After messing with it for a couple hours I happen to get it running perfectly, idles great, switches gears and runs in drive/reverse great WITH the cover off.

But then comes the interesting part, when I put the cover back it barely idles and will not stay running.

My question is, could the intake be getting blocked some how? or is it getting smoked out?



Any help is greatly appreciated and this site has helped me tremendously already getting my first starter boat running.

Thanks,

Rick
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,700
It either has exhaust leaking into the cowl, or the fresh air inlets for the engine are blocked. I can't remember if those engines inhaled down near the swivel bracket, or through the handle at the back of the cowl. We used to find wasp nests in the cowl inlets.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Running it in a barrel will do that. So will a blown powerhead gasket. It would be pretty difficult to block the air inlet.
 

PixelsGlastron

Recruit
Thread starter
Joined
Apr 22, 2016
Messages
5
Running it currently sitting on a boat lift with the tail dropped in for water circulation.
 

PixelsGlastron

Recruit
Thread starter
Joined
Apr 22, 2016
Messages
5
I'm almost certain it is an exhaust leak near the back somewhere that's allowing the exhaust to flood the inside of the case. No oxygen is getting to the motor and is killing it.

Now tell me the good/bad news on how easy it would be to fix an exhaust leak.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
The tilt handle/grip on the rear of the cowling is apparently removable, according to a parts diagram -- has a baffle and seal underneath. You might pull off the handle and fire it up -- see if that makes a difference. Maybe a venting issue up there.

Sometimes gets suggested the cowling might short out plug wiring. Maybe you could put on a glove and see if try to duplicate some kind of shorting that might be caused by contact with the cowling or latch.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
No Title

None of us can tell you where the leak is. But we can tell you where it might be. It might be the powerhead gasket (arrow in picture). Or it might be coming up through the drive shaft tube (second arrow in picture) if the exhaust seal #66, next picture is shot and #75 seal is missing form atop the water pump, OR the shift cable #52 is not seated in the adapter plate at the annular rings area.
 

Attachments

  • photo242298.jpg
    photo242298.jpg
    193.5 KB · Views: 0
  • photo242299.jpg
    photo242299.jpg
    229.1 KB · Views: 0

PixelsGlastron

Recruit
Thread starter
Joined
Apr 22, 2016
Messages
5
Thank you for all the replies I'll bust into the engine tomorrow to see if I can find the culprit!
 
Top