71 JOHNSON 100HP, NO SPARK IN ONE BANK

MICHAEL1153

Recruit
Thread starter
Joined
Jun 22, 2003
Messages
2
I BOUGHT A 71 STAR CRAFT CHEAP BECAUSE IT WOULD STALL AND NOT RESTART WHEN HOT. ENGINE IS A 100HP JOHNSON MOD# 100ESL71A, PREVIOUS OWNER PUT A NEW POWER PACK/SPARK AMPLIFIER ON IT. I FOUND A BROKEN HOT LEAD ON A COMPONENT CHAFING TO ENGINE GROUND. I'M STILL WAITING ON MY MANUAL TO GET HERE, THE COMPONENT IS HELD BY 2-BOLTS, IT LOOKS LIKE A FLASHER RELAY AS FAR AS SHAPE GOES. I HAVE EXCELLENT SPARK COMING OUT OF THE COIL, GOING TO A COMPONENT UNDER THE FLYWHEEL IT HAS THE 4 SPARK PLUG WIRES COMING OUT OF IT, ONE SIDE IS DEAD. FIRST, WHAT ARE THESE COMPONENTS CALLED AND 2ND, HOW CAN I TEST THEM? THE FLASHER RELAY LOOKING COMPONENT IS LOCATED BY THE SPARK AMPLIFIER AND DIRECTLY UNDERNEATH THE POWERSTRIP THAT HAS MANY WIRES GOING TO IT. IF ANYONE CAN HELP I WOULD GREATLY APPRECIATE IT, I WANT TO GET IT RUNNING SOON AND ENJOY WHATS LEFT OF THE BOATING SEASON AND GETTING IMPATIENT WAITING FOR MY SERVICE MANUAL. THANKS IN ADVANCE FOR ANY HELP! :mad:
 

mrc

Petty Officer 2nd Class
Joined
Dec 8, 2001
Messages
149
Re: 71 JOHNSON 100HP, NO SPARK IN ONE BANK

Flasher like unit sounds like the rectifier.<br /><br />Spark plug wires going under flywheel are going<br />to the distributer.<br /><br />There is a thin black wire with a white stripe which<br />goes from the amplifier to the points (under the <br />flywheel as well). Disconnect that black wire from<br />the amplifier at a big round pull apart connector<br />near the amplifier (looks kind of like a short inline<br />fuse connector). With ignition off and battery disconnected, verify via ohm meter that wire <br />goes to ground 4 times over the course of one full <br />rotation of the flywheel (The side of the wire <br />that goes under the flywheel)<br /><br />Regardless of if it does or doesn't your next<br />step is to pull the flywheel.<br /><br />After removing the flywheel, unscrew the two screws<br />that hold the stator coil from the block and<br />set the stator coil off to the side.<br /><br />The distributer cap can now be removed. If the<br />earlier test did indeed pull the black/white stripe<br />wire to ground 4 times per revolution of flywheel<br />examine the distributer cap and rotor for damage.<br />Check spark plug wires for continuity. Etc<br /><br />However the points did not pull black/white stripe<br />wire to ground 4 times, the problem is in the points. These are located under the rotor and <br />distributer cap. Set distributer cap aside and<br />remove rotor. Examine points (there are two <br />of them which each activated twice per rotation<br />of the crankshaft by a bulge in the crank shaft)<br />If need be, screw flywheel nut onto crank shaft<br />and rotate crank shaft with a wrench (probably <br />a good idea to make it easier by removing spark<br />plugs). From this you should be able to tell<br />which point is causing the problem and why.<br /><br />If neither of the above turns out to be the problem<br />get back to us with what you tried and saw.<br /><br />Good luck,<br />Mike
 

MICHAEL1153

Recruit
Thread starter
Joined
Jun 22, 2003
Messages
2
Re: 71 JOHNSON 100HP, NO SPARK IN ONE BANK

MRC, Thanks for the great and detailed info! I kinda thought that it was a rectifier but I was not sure. I think that the red hot lead off of the rectifier was his whole intermittent no start problem to begin with,(it was chafing to ground on the block of the engine) but that short probably took out a condensor or something along that line. I will bring some tools home with me tomorrow and give it a try, weather permitting. If you ever have car problems, feel free to drop me a line so that I may repay the favor! Once again Thanks and I'll post my results soon. <br /><br />Mike, <br />KC8OIT2@AOL.COM :)
 
Top