70hp Johnson Timing

jsentiff

Recruit
Thread starter
Joined
Jul 6, 2016
Messages
2
I have been working on a three cylinder, 1981 Johnson 70hp outboard. The motor runs pretty well but it doesn't like to idle for very long and it's response to the throttle is very sluggish.

I have re-built the carbs, checked the compression, cleaned the fuel filter, linked and synced the carbs, measured TDC to check the timing pointer, and put in new Champion spark plugs. The choke solenoid also works as it should.

The engine starts pretty easily, idles around 550 rpm, and WOT is somewhat over 5000 rpm. (That is not an easy measurement to take.)

The only strange thing I see is the idle timing is about 12 degrees ATDC. I have not measured the WOT timing. The idle timing seems very late to me.

Can someone tell me if this is reasonable, and if it is not, what do I do about it?

Thanks.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
You did not synch and link correctly. search for
Joe Reeves Timing method here on boats. I think it may even be in the sticky at the top of the page. Don't run it till you get that sorted out. Off the top of my head i think you will end up about 2 atdc roughly for the correct idle rpm and 19 btdc at wot but DO NOT QUOTE ME on that, I dont have those old manuals up here, they are in the shop.You did not synch and link correctly. search for

Well I tried to edit in a link but screwed it all up, you get the point I hope.
 
Last edited:

desertratz

Seaman Apprentice
Joined
Jul 16, 2017
Messages
49
idle timing should be around 2 degrees ATDC, your idle rpms are pretty low also.
 

jsentiff

Recruit
Thread starter
Joined
Jul 6, 2016
Messages
2
Thanks for the advice. I bought the service manual earlier this year and it does call for 19 btdc at wot. I found Joe Reeves timing method and will give it a shot when I get down there next week. I'll also go back through the link and sync procedure.
I'll let you know the results.

Thanks.
 
Top