70 johnson motor wont start

halibut1

Recruit
Thread starter
Joined
Jul 17, 2016
Messages
3
Hello out there in boating land ,I have a 1991 johnson outboard that wont start.the motor cranks over but its like there is a neutral switch or kill switch not working. Even though the motor turns there is no power going to plugs or coil,there is a bunch of wiring under the dash but i have no idea which is for what,can someone please help ,all set to take grand children fishing Mon
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Find the connector by the power pack. Disconnect it. Jump all the wires that are not blk/yel. This leaves the blk/yel open. Crank engine and look for spark. Report back.
 

halibut1

Recruit
Thread starter
Joined
Jul 17, 2016
Messages
3
thanks jakedaawg, not sure how to jump the wires,and which side of plug or right in power pack. this is my first time working on a boat motor this size
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
How do you know there is "no power going to the plugs or coil"? You would need a spark tester to properly test the end product (spark). With an adjustable tester, you should see about a half inch, sharp spark at each wire. As you mention the kill switch, assume you know that the clip has to be installed in the switch for the ignition to work (lanyard and clip at the remote control box, I assume).

Best chance for boating tomorrow is (hopefully) a simple fix -- make sure your starting procedure is correct. Cranking but not firing can be a kill switch issue (neutral safety switch wouldn't permit cranking). Make sure it's in the neutral detent position anyway, though, and move the remote lever back and forth a little. And make sure the little clip is in place. Make sure you have a fully charged, hot battery as the engine needs to crank at a good pace to fire up.
 

halibut1

Recruit
Thread starter
Joined
Jul 17, 2016
Messages
3
thanks for all your advice did the tests and found a dead coil ,and put on a new power pack,boat runs great
 
Top