7.5 mercury comet/lightening setting 30 years

wash-i-taw1

Cadet
Joined
Jul 4, 2013
Messages
7
I acquired a 7.5 merc that sat for 30 years inside. It appears in good condition, but I am guessing that I should be doing things to it before running it. Guessing there are seals and such that have dried out. Not sure of the year, but the serial is 3276477. Pointers on must do things? Haven't found a cross reference yet to the spark plugs AC V40FFK or what impeller it takes. Thank you
 

Attachments

  • 20240428_112250.jpg
    20240428_112250.jpg
    1.8 MB · Views: 5
  • 20240428_112300.jpg
    20240428_112300.jpg
    3.5 MB · Views: 5
  • 20240428_112426.jpg
    20240428_112426.jpg
    4.1 MB · Views: 5

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
49,769
  • raw water impeller (need to measure your driveshaft BEFORE you order the raw water kit, as the small mercs use either one of two diameter drive shafts .438" or .456".
  • may need a carb kit
  • service the lower unit - seals, oil, etc.
 

airshot

Vice Admiral
Joined
Jul 22, 2008
Messages
5,132
Check for dry rotted fuel lines, probably best to just replace all of them !! Same for electrical wires and connections, check for dried out and cracked wires. Clean all electrical connections, change out the lower unit lube, no need to replace seals unless you find a leak. Water pump yes by all means !!
Carb probably, but you might just try a good cleaning first. Spray some lube into each cylinder and crank it over a few times. Good luck
 

merc850

Commander
Joined
Jul 7, 2010
Messages
2,046
The wiring looks good, the fuel lines look good - I would replace the impeller (the serial Nr. makes it a 1972 model) check for spark and see if it runs. I've run many motors in worse condition.
 

wash-i-taw1

Cadet
Joined
Jul 4, 2013
Messages
7
So it looks like Clymers would be a good enough manual from what I can tell. Also, I have an external fuel tank with original hose/fittings. Tank is in excellent condition. Are there updated lines that will work with the motor or do I need to piece out fittings, etc. Thanks again.
 

Attachments

  • 20240428_151408.jpg
    20240428_151408.jpg
    2 MB · Views: 3
  • 20240428_152235.jpg
    20240428_152235.jpg
    2.2 MB · Views: 3
Top