6hp Evinrude Intermittent Problem.

rarbona1029

Recruit
Thread starter
Joined
Apr 18, 2017
Messages
2
Hello everybody. It's my first post here. I've been a lurker for a while, but this motor has me stumped.

I also posted this on the hull truth for anyone whos over there too.

It was sold to me may of 2015 as a 1967 evinrude 6hp fisherman.

The first half of the summer it ran great no issue till one day it started to drop to only running on the top cylinder.

It always cranks up in 1 or 2 pulls but the bottom cylinder keeps cutting out seemingly at random. just yesterday I drove it all the way home,from my fishing spot without a hiccup, but it ran on one cylinder most of the way there.

I've tried changing the plugs. It has AC Delco r45's in it. I also changed the coils to no avail as to me this seems like an ignition issue. im planning on doing points and plug wires next.

The compression tested a bit low on that cylinder. 65lb on bottom cylinder 78lb for the top.

What do you guys think I would love to have this thing running great without going to an outboard shop.

THANKS!! -Ricky
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Put in new coils ?-----When you changed the coils out did you remove the magplate "-----Did you loosen the wires so they could be inserted / screwed into the replacement coils ?-------Did you set the air gap on the COILS ?
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
How did the points look ?? Did you replace the condensers ??
 

rarbona1029

Recruit
Thread starter
Joined
Apr 18, 2017
Messages
2
No I did not remove the mag plate or loosen the wires or set an air gap. I just pulled the old ones out and slipped the new ones in. No change.The screw going into the plug wire was a bit long so it was a tight fit. I am currently waiting on points and condensors in the mail but the points look fine.

Thanks for the reply!
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
In the meantime, you can seat the flywheel over the key and shaft, maybe tap it down a bit with a leather or rubber mallet, and spin to see if there is spark. You need an adjustable spark tester ($10 at an auto parts store). The coils have to be set exactly flush on the mounting posts. Spray some WD-40 up into the plug boots (may want to reset the clips through the plug wire, which should have a metal core.)
 
Top