68 FD-22m lower unit confusion

moorlord

Recruit
Thread starter
Joined
Jun 21, 2017
Messages
3
Hey guys, long time lurker finally hit a roadblock. I am restoring my grandfathers johnson FD-22m and am currently rebuilding the lower unit. I have a 0313284 sierra oil seal here that is too small. The O.D measurement for the the new seal is 1.12 (1 1/8) while the old seal appears to be 1-1/4 (ruler measurement). The new seals inside diameter works just fine. This is the exact part specified in the part list I have so apparently something was changed? My grandfather claims that the prop shaft may have been replaced back in the 80's and doesn't recall the gearcase head being replaced although this could be the case. My question is does anyone know the part number for the 1-1/4 seal or would it be better to try and find the 1-1/8 gearcase head instead? Gramps has several lower units and a few boxes of parts I may be able to find one in I'm just a little hesitant to swap out individual parts in a gear assembly that has been working for so long. I'm fairly new to all of this and so would be greatful for any advice. Thanks a-lot. Moor
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Somebody has changed the gearcase head (or the whole lower unit). The older, larger, seal that you need is part number 302495.
 

moorlord

Recruit
Thread starter
Joined
Jun 21, 2017
Messages
3
Much appreciated. I know the lower unit is original as its one owner. So it must be as you say the gearcase head.
 
Top