'66 chrysler 105

ltj126

Recruit
Thread starter
Joined
Jul 2, 2006
Messages
2
I have a '66 chrysler 105 that ran good last year when I put it in this year it would run great to start off then fall on it's face. I noticed it was sucking air in the the fuel so I replaced the fuel lines but on the test drive the cylinder 2nd from the bottom seized up. The other 3 still move as much as I can turn the crank by hand. Any ideas what it could be?
 

jerryjerry05

Supreme Mariner
Joined
May 7, 2008
Messages
18,196
Re: '66 chrysler 105

Could be the sucking air ran it too lean and it scored/seized the cylinder???
Pull the head and check the cylinders.
I think the 2nd cylinder is the fuel pump cylinder.
The vacuum from #2 actuates the pump.
Possible the diaphragm is bad and sucking air there?
Take the side covers off and check the damage to the piston skirts.
Ethanol is messing up a lot of motors!!!

Post pics.There are lots of parts for these motors.
Profile,location? You might be close to someone who can help?
 

ltj126

Recruit
Thread starter
Joined
Jul 2, 2006
Messages
2
Re: '66 chrysler 105

Ok great thanks. Sounds like a great place to start
 
Top