60hp Evinrude, Rev problems, Under powered,Help!!

PeterJay

Recruit
Thread starter
Joined
Jul 4, 2003
Messages
3
Hi all,<br /><br />I have recently bought an old 60hp Evinrude outboard attached to a fletcher Arrow 14ft. I presume it must be dated to the 70's. When we go out on the water and we open up the throttle it just acts like a smaller engine and the revs wont exceed 3000rpm. I have a spare engine and have tried swapping the parts as they are the same but no luck!! Checked the black box by swap test, not tried coil yet, got spark on all 3 plugs, compression fine, carbs opening fully, fuel OK, tidied up the wires but still no joy. I think it must be something to do with the timing.<br /><br />Please Help<br /><br />Best<br /><br />Pete
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: 60hp Evinrude, Rev problems, Under powered,Help!!

Pete,post the model number of engine so that we can determine the year model and be of better assistance.Your symptom off hand sounds like the carbs are in need of servicing.Insure the timer base moves freely and unrestricted through complete throttle range and comes to rest against its rubber stop at full throttle position.
 

PeterJay

Recruit
Thread starter
Joined
Jul 4, 2003
Messages
3
Re: 60hp Evinrude, Rev problems, Under powered,Help!!

Hi,<br /><br />Yes I shall get the model number from the outboard tomorrow. All the carbs are fine all throttle and timing rods have full movement to their stop positions.<br /><br />Thank you <br /><br />Pete
 

Solittle

Fleet Admiral
Joined
Apr 28, 2002
Messages
7,518
Re: 60hp Evinrude, Rev problems, Under powered,Help!!

When you say the carbs are fine - Did you rebuild them and put a kit in? Carbs that open fully and look clean on the outside are often packed with crud on the inside.
 

PeterJay

Recruit
Thread starter
Joined
Jul 4, 2003
Messages
3
Re: 60hp Evinrude, Rev problems, Under powered,Help!!

I managed to get a Marine Engineer to have a quick look and he checked the fuel line and carbs and told me they were OK. He told me to check all the connections for leaks, which I did.
 
Top