57 Fastwin 18 Problem

peacemaker48

Cadet
Thread starter
Joined
Jan 8, 2016
Messages
22
Hello once again. The timing set up using the VOM went very well. Now the motor will crank and run as it should. However at the lake test yesterday the motor gave me another issue to deal with. It began to seemingly slip out of gear at high speed but there wasn't a noticeable sound like grinding of gears but just a feeling of the clutch slipping in a vehicle and the motor revving too high. When this happened I would throttle back and it would slip back into gear. The problem seemed to be getting worse so I headed back to the dock before doing any further damage. I have included a minute long video of which the last five seconds will show the problem much better than my attempt to explain. Once again any help would be very appreciated. Thank you.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
No Title

Two things cause slippage without banging or grinding. 1: A spun prop hub. 2: Ventilation or cavitation, which is air around the prop. Easy way to tell if the prop hub is slipping is to make a mark on the prop nut (the cotter pin will serve) and another mark on the propeller body, aligned with the first mark. Run the motor till slippage occurs, then stop motor and check the marks. If they no longer line up, the hub slipped. If they do line up, repeat the test, there is a slim chance it stopped slipping in the same position.
 

Attachments

  • photo49297.jpg
    photo49297.jpg
    87.5 KB · Views: 0

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
It wants us to sign up for dropbox
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
my 2 cents -- Motor sounds very good now! That current problem -- In addition to other suggestions, worth trying a different trim setting, check placement on transom (motor height), and check the boat bottom -- should be smooth with no hook.
 

peacemaker48

Cadet
Thread starter
Joined
Jan 8, 2016
Messages
22
Thanks OB1 I've just got back from the lake and the prop is slipping on the hub apparently. I made the marks as F_R suggested and the marks had moved . I repeated three times with the same results. Do you get a new hub with a new prop ? I'm not sure how it all fits????
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If it were me, I would go to a prop shop -- replacement prop might be the choice, depending on costs. Got a solution, though. That's good.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Diameter and pitch is shown on the prop (hub or on a blade). First number is size/diameter, second number is pitch. So 9 X 10 would be a 9 inch diameter prop, 10 inch pitch. That is probably what you currently have. The nut should be fine.
 

peacemaker48

Cadet
Thread starter
Joined
Jan 8, 2016
Messages
22
Thanks ob1. I had looked earlier and didn't see the size because of some old white paint , but your right 9X10 and I'll reuse the nut.....
 
Top