56 Johnson 30HP clutch dog direction

ishirock

Recruit
Thread starter
Joined
Mar 12, 2016
Messages
2
Hello, first post here, but have been gathering tons of great info to get my big Johnson back in service:)....thank you. Anyway, I'm repairing a 56 30HP Johnson with a worn Clutch Dog. I purchased a new dog and machined the surfaces on the gears where the dog ears meat the gears.

The new Clutch dog is a bit different design than the original. The original had a raised ring around where the spline are located on each side. The new one does not have this and I researched that this is OK.

Here is my question:

The ears on the dog have grooves on them in one end and I don't know if those go towards the prop (reverse?) or the towards the front (forward?) gear.

I will post a pic if what I'm saying isn't making sense.

Cheers,
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
You may find that you can switch bushing on the gears.----Then use reverse gear as the forward one.
 

HighTrim

Supreme Mariner
Joined
Jun 21, 2007
Messages
10,486
As Frank stated, the groove indicates the forward side, however, there is no difference between the sides. If you put it in the other way, the motor wont know the difference! I flip them all the time when the forward side is worn beyond use and the owner does not want to buy a new one.
 

ishirock

Recruit
Thread starter
Joined
Mar 12, 2016
Messages
2
Thanks guys. I figured it should go forward to add lubrication, but wasn't sure why they just wouldn't groove both ends.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Nothing to do with lubrication.----On many motors the dog lugs have a slight angle to properly engage the lugs on the forward gear.
 
Last edited:
Top