50 HP 1980 Evinrude Idle issues

cidporter

Recruit
Thread starter
Joined
Aug 11, 2017
Messages
5
So I have an elderly Mckee Craft with a 1980 50 hp envinrude outboard. I purchased and fixed the motor last summer and road it several times with little issue. I have taken it out twice so far this summer so far. First time out ran beautifully with no issue whatsoever. Today unfortunately i ran into some issues. I unloaded the boat, started and let her run for good 5-10 min. was cruising at a low speed for no wake purposes and also to let the motor warm up some more. after reaching a little farther into the bay i felt confident in bringing it to a higher speed quicker than i usually do. She did not like it after 30 sec of riding. She came down to a lower speed by itself and remained there no matter how much throttle i gave it unless i really gave it a lot but i avoided doing so for obvious reasons. When i reached the area where i wanted to fish i put it in idle, but the motor was still in forward gear, so i moved the lever back into forward than back into idle to see if the issue would fix itself but instead the motor went into an extremely high rev. I started her back up and same thing. now stranded with paddles going against tide i started her up and quickly put it in forward at a low speed and cruised back to the dock. It is extremely strange to me that as soon as i put it into idle the motor does not stop and the rev increases rapidly. Off the bat i am assuming there could be some cable tangle? Please respond with any advice to fix and or ways to avoid this in the future.
 

ahicks

Captain
Joined
Sep 16, 2013
Messages
3,957
Not much doubt here your control is starting to fail, has failed, or is out of adjustment. Not a lot of room for error there. Sounds like you need to remove the engine hood and carefully check what's going on while shifting.
 

Sea Rider

Supreme Mariner
Joined
Sep 20, 2008
Messages
12,345
Assuming it's a 2 strokes engine, those don't like to be warmed up for long time periods. From a cold enginestrat, a max 5 minutes will suffice. Those engines tend to fould plugs prematurely due to plugs not reaching their self cleaning temp. Do a max 5 minutes warm up and soon aflter open throttle gradually for combo to plane out and burn oil deposits on plug's tip till your fishing spot is reached.

If you'll be trolling, idling excesively when fishing, on your way back to terra firme throttle engine as if stealing the combo to clean plugs and start the whole warming procedure on next outing with cleaned plugs.

Disconnect throttle cable, remove cowl and visually check if the whole throttle system it's doing its homework right when gradually being throttled to full wot, if OK, check if the cable box alone is working right. Assemble the whole throttle sistem back and check if both are working OK hand in hand.

Check that the carb's butterfly rotates freely closing and opening when actuated and is, are not stuck at some point if engine has one or more than one carb, if so, lightly lube with thin oil the butterfly's side rods and with hand open and close it severeal times till rotates freely without jamming. Next time the choke is actuated the butterfly will work smoothly.

If all is found OK, could be anything apart from the throttle system, worse being a 37 yeal oldie. Good Luck!!

Happy Boating
 
Top