Hi, had a 302 Cleveland in a Stingaaaa ski boat with shaft drive and dog clutch. Looking at dropping a 5.8 OMC Cobra motor into the Stingaaaa. Just not sure if it’s possible on how the dog clutch would be set up. Is there a adaption plate or housing that goes onto the motor.
Any thoughts or ideas would be appreciated.
1st photo is original setup
2nd photo is the back end of the 5.8ltr.
The original housing won’t fit. Totally different
Any thoughts or ideas would be appreciated.
1st photo is original setup
2nd photo is the back end of the 5.8ltr.
The original housing won’t fit. Totally different
