4hp Evinrude died on lake, won't start

FlightCanceller

Recruit
Thread starter
Joined
Nov 14, 2016
Messages
5
I took the ole 4HP evindude out yesterday for the first time this year with a new tank of 50:1 gas and she started 3rd pull. It would run good with the choke on but as soon as I pushed in the choke it would start to sputter and want to die. I decided to see how far I could get the choke in and it ended up dieing and wouldn't start back up. I've pulled plugs, checked fuel flow, everything I can think of and it just won't fire again. What could the problem be?

P.s. always bring a paddle kids! Without it I literally would've been up $h!ts creek!
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
How old is an " ole 4hp " motor.-------Model # should be posted !
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Big believer in paddles and oars. Maybe some old fuel has gummed up the carb. Or if you have a fuel pump, might have a diaphragm that is torn or lost flexibility.

Overheating is always a possibility (usually impeller issue). 50:1 ratio may be on the lean side depending on age of the motor.
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
back to basics...


​motor seems to have staved out after lots of choking I assume plugs are firing but check them anyway
​test compression also 70 plus lbs would be minimum

depending on year...

tank vent open and 2 holes clear of crud...?? try engine with no gas cap screwed down ......if OK 2 vents holes crudded inside the cap
tank internal screen filter crudded up
pump inlet blocked and/ or pump not operating but this motor likely has no pump anyway (gravity fed.... with pet **** on the side)
fuel to carb not happening open side fuel valve 100% if so eqpt'd
​ carb inlet needle crudded -stuck
​carb needs good overall with carb cleaner and lots of air pressure to clean all passageways

make sure it is pumping water !!
 

FlightCanceller

Recruit
Thread starter
Joined
Nov 14, 2016
Messages
5
It's a 1971 Evinrude Lightwin.

After a little more playing around with it I have determined that there's no air getting into the cylinders. I have gas and hot spark but no air. No suction from the intake manifold. I rested the plugs right outside the holes and it went off perfectly so now the issue is finding out why I'm not getting air into the cylinders
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Get your hands on a compression tester, and see what you have. You also need to measure spark with and adjustable open air tester from an auto parts store (cheap). Spark should be around 3/8 inch (look for a half inch and work back) -- should be able to clearly see and hear it. If you have compression and spark, the motor should start after priming it with the bulb. If you can't keep it running, suspect the fuel pump diaphragm.
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
what is the engine model and year ?????? top tank side tank on a hose ??? top tank has no fuel pump (gravity feed to carb)



​squirt gas in the carb face if it goes the carb is not doing its job of providing fuel

​ feel for suction on the carb face while starting...... doubtful cyl are not... getting (sucking) air
 

FlightCanceller

Recruit
Thread starter
Joined
Nov 14, 2016
Messages
5
Checked compression on both cylinders...60lbs on both... no suction from intake on carb when turning over...won't even sputter with starting fluid down carb...out of ideas, thinking compressions too low
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Very important question needs an answer.-----Does spark jump a gap of 5/16" , yes or no ?
 

FlightCanceller

Recruit
Thread starter
Joined
Nov 14, 2016
Messages
5
Ended up breaking the pull start spring so that will have to wait, should have an answer for you by tomorrow.

On a side note, is it easier to replace the whole assembly or just the spring?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Pull the flywheel over with a rope to check for spark.-That recoil is not considered robust.----I would not spend any money on that till motor is starting / running properly.
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
compressionis low but not terminally ill.... get it going and run some decarb in it to see if #s come up


low compression should not stop the fuel exploding.... heck lighter fluid can blow in a beer can...

​concentrate on ignition (good spark) as suggested.... then good gas....... air intake should not be an issue

open up the choke and throttle plates
 
Top